jph
Full Member
Posts: 131
|
Post by jph on Aug 9, 2014 7:22:52 GMT -5
looks good! were did you get him? Are you going to put a little tony's on it?
|
|
|
Post by Tony Howard on Aug 11, 2014 22:39:11 GMT -5
This will be a self contained processor. I have removed the freezer unit and will be installing an air conditioner window unit. I got it set and level Sunday evening. I had to cut a hole in my new wall for the side door to enter the box. Next year I hope to have a top over it and for the most part totally enclosed to look like part of the shop. When I laid the slab two years ago I place conduit to the north inside wall. I pulled three 10ga and two 12ga stranded wire in the conduit this evening. This will be enough for either 30 amp 220 plus a 15 amp 120 or two 20 amp 120 with a 15 amp 120. I wanted to make sure I had large enough wire to pull a little load if needed. It is the further point from the supply as well. I did not have the conduit connectors needed to start building the circuits so I worked on the door handle till time for bed. I am changing out the outside only truck style locking door handle to a cooler pull handle with panic button inside. I have to wash it thoroughly with the pressure washer and get it all cleaned up inside and out. I want it to look nice and clean. Lot of work left to do and very little time to do it. Also by next year I hope to have the top of the shop trimmed nicely as well. running out of $$$$ Attachments:
|
|
|
Post by Tony Howard on Aug 11, 2014 22:40:30 GMT -5
you can see how close I got it to the shop. Also have to plumb it with hot and cold water and drainage. Attachments:
|
|